BT Internet Radio

From Sharpfin
Jump to: navigation, search

Introduction

This radio first appeared in late 2006.


Pictures

Front view
Rear view
Controls panel
Display
Volume Control
Dial
Power switch and headphone socket

Photos reproduced with the permission of Logikir100.tripod.com


Opening the BT Internet Radio

This is one of the easier radios to open.

  • Remove the 4 recessed screws from the back of the case.
  • Turn the radio upside down and carefully separate the two halves of the case by no more than 1 to 2 inches.
  • Look inside and you will see 3 red/black cables near the bottom of the case. Carefully detach them from the main circuit board.
  • You can now fully open up radio.
Front view


Firmware

v255-c-194 - circa 2006

No official upgrades available as of April 2010.



User Manual

http://www.shop.bt.com/content/uni2/documentation/4bdq/028983.pdf


Power Supply Unit

Supplied with a 7.5V @ 1.1A switched mode mains power adapter. DC power plug specifications are: 5.5mm diameter/2.1mm inner diameter/12mm long barrel, centre positive polarity. If you are sourcing a replacement, note that a short 9mm length plug will NOT fit this radio properly.

How to add remote control to the BT Internet Radio

http://logikir100.tripod.com/irmod.htm